Shoe insulation testing machine

The shoe insulation testing machine is mainly used for welding protective shoes, high-temperature shoe sole materials such as rubber, polymers, etc. to test their high-temperature resistance. After testing, there should be no softening, melting, cracking or other phenomena on the surface of the outsole sample. The testing method is to heat the sandbox to 150 ℃, let the sand cover the contact area between the sample shoe upper and sole, and record the temperature change of the insole over time within 30 minutes, accurate to 0.5 ℃.

Experimental principle:

Place the test sample in a sand bath at the specified temperature and maintain it for the specified time. By measuring the temperature inside the test sample or before and after the insole, evaluate whether the test sample has insulation performance and its effectiveness based on the magnitude of temperature change and the severity of damage to the test sample.

Compliant with standards:

ISO 8782-1, ISO 20344, LD32, LD4, GB/T 20991 Part 5.12 standard requirements.

Specification parameters of shoe insulation testing machine:

Sand size: (40 ± 2) cm x (40 ± 2) cm, with a minimum height of 5cm

Sand volume: 5000 ± 250cm3

Sand particle size: 0.3-1.0mm

Oven plate temperature: room temperature~150 ± 5 ℃ or 250 ± 5 ℃

Heating power: 2.5KW

Heat transfer medium: standard Ф 5mm steel ball

Copper/Copper Nickel Thermocouple: Welding a copper disk with a thickness of 2 ± 0.1mm and a diameter of 15 ± 1mm

Temperature control accuracy: ± 2 ℃.

Temperature recorder: automatic temperature recording

Sand bath: equipped with a heating plate that can be adjusted to 250

External dimensions: approximately 105 x 45 x 55cm

Standard configuration: Steel ball, with a diameter of 5mm stainless steel ball and a mass of 4kg