Site: Home > Home > Products > Property > Other

Advanced Capillary Flow Porometer

Description:Advanced Capillary Flow Porometer is fully automated and designed for linear turbulance-free test gas flow.

Factory Direct SalesQuality AssuranceLightning DeliveryHassle-free Service
Free Quote
Advanced Capillary Flow Porometer

Product Details

Advanced Automated Porometers yeild very objective, accurate and reproducible results, considerably reduce test duration, and require minimal operator involvement. The machine is fully automated and designed for linear turbulance-free test gas flow. The pressure is measured close to the sample and therefore, the correction term in the differential pressure measurement is minimized. Required amount of pressure is uniformly applied to the o-ring seals on the sample and the need for hand tightening the cap on the sample chamber is eliminated. Automatic addition of wetting liquid reduces test time appreciably. This sophisticated instrument has found applications in a wide variety of industries.
 A wetting liquid is allowed to spontaneously fill the pores in the sample and a nonreacting gas is allowed to displace liquid from the pores. The gas pressure and flow rates through wet and dry samples are accurately measured. The gas pressure required to remove liquid from the pores and cause gas to flow is given by
D = 4 g cos q / p
where D is the pore diameter, g is the surface tension of liquid, q is the contact angle of liquid, and p is the differential gas pressure. From measured gas pressure and flow rates, the pore throat diameters, pore size distribution, and gas permeability are calculated.

◆ No need to undo the sample chamber for wetting the sample. The sample is not disturbed during wetting. See-through sample chamber available for visual observation of test.
◆ Considerable reduction in test duration. Exactly the same area is tested. Results are more accurate and reproducible
◆ The sample chamber at the bottom of the piston rod contains o-rings on the outside to prevent leak between the insert and the sample housing of the sample chamber
◆ The need for cutting samples for testing is eliminated.
◆ Testing of small samples as well as complete parts
◆ Many sample geometries (example: sheets, rods, tubes, hollow fibers, cartridges, and powders)
◆ Use of many nonwetting liquids (example: water, alcohol, silwick and galwick)
◆ Tests in QC, research, or any number of user-defined modes
◆ See-through sample chamber available for visual observation of test
◆ Real-time graphical display. Windows-based software for all control, measurement, data collection, data reduction, and report preparation.Fully automated and computer controlled

Technical Parameters
Items Parameters
Pore Size Range 0.013 - 200 microns
Premeability Range 1 x 10 -3 - 50 Darcies
Sample Size 1.75” - 2.5” diameter
Maximum Pressure 500 psi
Pressurizing Gas Clean, dry, and compressed air or nonflammable and noncorrosive gas
Pressure Transducer Range 0 - 500 psi
Flow Rate 200 LPM
Resolution 1 in 60,000
Accuracy 0.15% of reading
Mass Flow Transducer Range 10 cm³/min - 500,000 m³/min
Power Requirement 110/220 VAC, 50/60 Hz (others available)
Dimension 61” H x 30” W x 26” D

Related Products

Leave Message

Send message or email get favorable prices,reply tu you within 24 hours!

Copyright 2022:Qinsun Instruments Co., Limited

High-end textile tester supplier | Textile Testing Equipment pdf | Tel:021-67800179 |